News for hackers. Stuff that matters.
Re:Analysis of SSD Reliability during power outages by zAy0LfpBZLC8mAC on Saturday December 28, 2013 @07:57AM (#6974894)
Hu? Where should that spike in power usage come from?
Re:Analysis of SSD Reliability during power outages by rational_indian on Saturday December 28, 2013 @09:12AM (#6975009)
It comes from the decoupling/filter capacitors used in the DC power circuit. When the power is turned on after a sufficiently long time these capacitors are all uncharged and appear as "shorts" to the power source thus drawing large amounts of current. This initial surge current drops off as the capacitors get charged.
Re:Analysis of SSD Reliability during power outages by zAy0LfpBZLC8mAC on Saturday December 28, 2013 @01:42PM (#6975724)
Filter capacitors producing excessive heat due to inrush current? That would be bad filter capacitors indeed ;-)

The claim was that an SSD somehow converted more electric energy into heat immediately after power-up which would damage the SSD, so real consumption, not just a current peak that goes into storage for later consumption. Normal-ESR electrolytics might have a heat problem when used at a few kHz in switching applications, but certainly not at 0.1 Hz.

Re:Analysis of SSD Reliability during power outages by CamperBob2 on Saturday December 28, 2013 @03:46PM (#6976477)
It's long been standard practice with tantalum filter capacitors to feed them through an inductor or at least a resistor to prevent inrush current failures. That, and/or you derate the crap out of them when you design the board. Newer drives are probably using multilayer ceramics that can put up with just about any abuse including inrush.

Executive summary: powerup stress is not an issue unless the drive was designed by a moron.