Re:UK police mistakenly believed they found 3D printed gun i...
by choult on Friday October 25, 2013 @08:36AM
(#6611176)
I should imagine the "scary" part for security services is the fact that it's printed in plastic and therefore much harder to detect, not that it's home-made.
[ Parent
| on HN ]
Re:UK police mistakenly believed they found 3D printed gun i...
by tobiasu on Friday October 25, 2013 @08:50AM
(#6611240)
Nothing stops you from milling and turning plastic. Not only that, there are many heat resistant plastics on the market that are far stronger than some poorly bonded ABS.
Re:UK police mistakenly believed they found 3D printed gun i...
by lewispollard on Friday October 25, 2013 @09:27AM
(#6611422)
I may be wrong here, but don't 3d printed guns still need a metal firing assembly to work? Would that be enough to detect?
Re:UK police mistakenly believed they found 3D printed gun i...
by Sanddancer on Friday October 25, 2013 @11:41AM
(#6612247)
The Liberator derringer[1] which caused such a fuss a few months ago only needed a nail, which wouldn't be detected under most circumstances. I imagine that using an epoxy pin would probably be suitable given the gun's other single-fire characteristics.
[1] It's single shot, uses a low-powered cartridge, and is a bitch to reload; calling it a handgun is an extreme stretch.
Re:UK police mistakenly believed they found 3D printed gun i...
by frezik on Friday October 25, 2013 @11:55AM
(#6612328)
They put in a metal firing pin because 100% plastic guns are illegal in the US. It was technically capable of being completely plastic.
But like the other poster said, it's a one-shot pistol with a weak cartridge. It's a long way from a practical firearm that will survive more than 10 shots.
Re:UK police mistakenly believed they found 3D printed gun i...
by GVIrish on Friday October 25, 2013 @09:28AM
(#6611429)
No one should be alarmed by a non-metal firearm until someone figures out how to make plastic bullets.
Re:UK police mistakenly believed they found 3D printed gun i...
by D9u on Friday October 25, 2013 @09:49AM
(#6611541)
http://www.guns.com/2013/01/02/flare-guns-as-weapons/
Shotgun shells are mostly plastic.
Re:UK police mistakenly believed they found 3D printed gun i...
by GVIrish on Friday October 25, 2013 @10:34AM
(#6611840)
You make a good point with flare guns, but I wouldn't be terribly afraid of them. Maybe someone on a plane could cause a lot of panic with flare gun but that's not much different that causing a fire with other means. You might be able to kill someone with the initial shot, but that's it.
In a shotgun shell, the pellets (or slug) and primer section are still metal. You couldn't smuggle a shotgun shell through a metal detector any more than you could smuggle a regular bullet through.
Re:UK police mistakenly believed they found 3D printed gun i...
by growupkids on Friday October 25, 2013 @10:57AM
(#6611978)
The shot, however, is not plastic.
Re:UK police mistakenly believed they found 3D printed gun i...
by CapitalistCartr on Friday October 25, 2013 @10:19AM
(#6611730)
Loaded full of metal pellets.