Re:Apple shows us the amazing process of making the Mac Pro
by Osmium on Thursday October 24, 2013 @08:24AM
(#6604793)
You may well be right, but I think the key claim is this:
"Most metal stampings go through one or two die tools to produce the final shape. With the Mac Pro though, the challenge is to produce a massive amount of plastic deformation without tearing, rippling or deforming the perfect cylindrical surface."
and, below the figure:
"The results of the first (of between 4 and 5) deep draw stamping operations. Notice how the Mac Pro part is nowhere near the final length."
As I'm sure you know, there's a big difference between a single-use aluminium can, which is both small and thin, and a large part like this, which has to have both structural stability, very high dimensional tolerances, and a good surface finish. That said, you obviously know more about this than I do, so maybe you can comment on the quotes from the article?
"Most metal stampings go through one or two die tools to produce the final shape. With the Mac Pro though, the challenge is to produce a massive amount of plastic deformation without tearing, rippling or deforming the perfect cylindrical surface."
and, below the figure:
"The results of the first (of between 4 and 5) deep draw stamping operations. Notice how the Mac Pro part is nowhere near the final length."
As I'm sure you know, there's a big difference between a single-use aluminium can, which is both small and thin, and a large part like this, which has to have both structural stability, very high dimensional tolerances, and a good surface finish. That said, you obviously know more about this than I do, so maybe you can comment on the quotes from the article?