News for hackers. Stuff that matters.
Re:The humble USB cable is part of an electrical revolution by pjc50 on Tuesday October 22, 2013 @10:16AM (#6592017)
Ethernet's magnetically isolated transcievers are a bit pricey, though. Recently I've been wondering about rallying the Arduino crowd behind RS485 or CANBUS for this sort of connected cheap device network.
Re:The humble USB cable is part of an electrical revolution by fancyketchup on Tuesday October 22, 2013 @04:04PM (#6594551)
That (CANBUS and RS485) works ok as long as everything agrees on what "ground" is. Using differential signaling (as both those standards do) does give you some noise immunity and does help with the ground issue somewhat.

The problem is that ground loops can easily generate 10's of volts at the highest impedance point, and there will be ground loops if you try to use this for "smart homeish" things. Most bus drivers and receivers aren't meant for voltages that high--many drivers/receivers have absolute maximum ratings only a few hundred millivolts below ground.

Isolating everything isn't a conceptually difficult thing to do, but you'll spend just as much on optoisolators as you would have on ethernet magnetics.

Re:The humble USB cable is part of an electrical revolution by alsothings on Tuesday October 22, 2013 @10:36AM (#6592164)
CANBUS +1. Would love to nudge the ardunio-ish end of the IoT community in that direction.
Re:The humble USB cable is part of an electrical revolution by pjc50 on Tuesday October 22, 2013 @11:05AM (#6592366)
It's the right protocol, but the licensing requirements are a real problem. Whereas RS485 is free but not a complete solution.