News for hackers. Stuff that matters.
Re:Why Registers Are Fast and RAM Is Slow by demallien on Friday October 11, 2013 @02:52PM (#6535119)
Or on a more light-hearted note: http://folklore.org/StoryView.py?project=Macintosh&story=Sou...

Which just goes to show, hitting memory is a Bad Thing(tm) even when you're running on a slow(from today's perspective) processor like a 68000.

Re:Why Registers Are Fast and RAM Is Slow by raverbashing on Friday October 11, 2013 @03:40PM (#6535447)
Very impressive

Doing 22kHz generation on a Macintosh is very close to the limit

Re:Why Registers Are Fast and RAM Is Slow by derleth on Friday October 11, 2013 @10:01PM (#6536941)
It wasn't always thus: On the 6502, which the early Apple II machines were built around, it was possible to access RAM at only a one- or two-cycle penalty compared to doing everything in registers and immediate values. This was only the case if you used zero-page memory without indexing, however, so you couldn't have a lot of stuff in RAM without incurring more speed penalties.

http://www.6502.org/tutorials/6502opcodes.html

(Zero-page memory on the 6502 was the memory accessed via addresses with a high byte of 0x00. Since 6502 had sixteen-bit RAM addressing, this meant each page was 256 bytes large, so the zero-page was almost as good as having 256 single-byte registers.)