News for hackers. Stuff that matters.
Re:A 3D printed toothbrush for all your teeth by EvanAnderson on Tuesday October 01, 2013 @02:21PM (#6478054)
The only damage that I've ever read about re: over-brushing has been enamel damage caused by abrasives in toothpaste. The bristles of the brush should be much softer than enamel.
Re:A 3D printed toothbrush for all your teeth by npsimons on Tuesday October 01, 2013 @03:00PM (#6478337)
My dentist had to fill in spots near my gums on my upper molars that were worn down; I seem to remember him telling me not to brush so hard.
Re:A 3D printed toothbrush for all your teeth by marcosdumay on Tuesday October 01, 2013 @05:48PM (#6479302)
I had this problem for ages, in the end, the actual problem was gastrits. Any gastric problem has that same simptom, so if it persists, go check for them.
Re:A 3D printed toothbrush for all your teeth by tripzilch on Wednesday October 02, 2013 @05:22AM (#6481455)
I don't doubt you, but that might also have been advice for after the filling perhaps? The stuff they fill it with is not nearly as hard as the stuff on the outside of your teeth (which is pretty damn hard). So a filling will always be a weak spot.