News for hackers. Stuff that matters.
Re:Chemists Work to Desalt the Ocean for Drinking Water, One... by sbierwagen on Thursday July 11, 2013 @12:43AM (#6024495)
The actual paper ( http://libgen.org/scimag5/10.1002/anie.201302577.pdf ) says they manage an efficiency of 25 mWhL^-1 (90 joules per litre)

Where did you get that 0.7A number?

Re:Chemists Work to Desalt the Ocean for Drinking Water, One... by solox3 on Thursday July 11, 2013 @12:47AM (#6024505)
0.7A is the current of the "store bought" (AA) battery, suggested by the article.

To make this technology energetically favourable to boiling, it must not exceed ~700μA in current, and it has to be far less than that to be worth its complexity.

Re:Chemists Work to Desalt the Ocean for Drinking Water, One... by sbierwagen on Thursday July 11, 2013 @12:56AM (#6024519)
Uh? No battery[1] delivers a constant amount of current: http://en.wikipedia.org/wiki/Ohm%27s_law

Solving for current, Ohm's law is I = V/R. You only deliver .7 amps of current into a 4.285 ohm load.

If you connect a 3 volt battery to a 1,000 ohm resistor, then only 0.003 amps of current will flow, which is 9 milliwatts.

Connect a 3 volt battery to a .01 ohm load (a dead short, almost) and 300 amps of current will flow, (900 watts!) very briefly, until the battery voltage sags under load.

1: Or any voltage source in general, barring some trickery that you can't do with a simple electrochemical battery.

Re:Chemists Work to Desalt the Ocean for Drinking Water, One... by ScottBurson on Thursday July 11, 2013 @02:48AM (#6024795)
> Connect a 3 volt battery to a .01 ohm load (a dead short, almost) and 300 amps of current will flow

Except it won't, of course, because all real batteries have internal resistance. (How much depends on the battery chemistry and size.) Probably the 700mA rating for the AA battery is into a dead short.

Re:Chemists Work to Desalt the Ocean for Drinking Water, One... by HCIdivision17 on Thursday July 11, 2013 @01:45AM (#6024639)
I had an electrical engineering old timer explain the misconception as the Current Push Theory. (His industrial war stories were pretty good.)
Re:Chemists Work to Desalt the Ocean for Drinking Water, One... by jonmrodriguez on Thursday July 11, 2013 @02:13AM (#6024719)
Googling for "Current Push Theory" only gets 5 results, none of them relevant: https://www.google.com/search?num=100&q=%22Current+Push+Theo...

Can you please define the Current Push Theory?

Re:Chemists Work to Desalt the Ocean for Drinking Water, One... by sbierwagen on Thursday July 11, 2013 @02:48AM (#6024792)
He might be referring to the "hydraulic analogy" of electricity: A wire is a water pipe, voltage is water pressure, amperage is total water flow. A battery is a pump pushing water through the pipes, voltage is how hard the pump pushes, and amperage is limited by how wide the pipes are, and thus how much resistance they impose on the flow of water.

http://en.wikipedia.org/wiki/Hydraulic_analogy

http://hyperphysics.phy-astr.gsu.edu/hbase/electric/watcir.h...

Re:Chemists Work to Desalt the Ocean for Drinking Water, One... by HCIdivision17 on Friday July 12, 2013 @06:25PM (#6035668)
The basic idea was that you can't put a 5kW drive on a 2.5kW motor: it would shove too much power into the motor and break it. This is not quite at all how those systems work.
Re:Chemists Work to Desalt the Ocean for Drinking Water, One... by jonmrodriguez on Thursday July 18, 2013 @05:17AM (#6062588)
Doesn't it depend on the situation?

E.g., if you have a resistive load and an inductive power source, the power source will keep upping its voltage until the load accepts the current that's being shoved down its throat.