So one one hand you need to understand your host processor (and it's constellation of helper chips) inside and out. Some modern SoC systems like the ones in smartphones have everything built into the same chip, so you wind up combing through 5,700 page Technical Reference Manuals like this one for the Freescale i.MX6:
http://cache.freescale.com/files/32bit/doc/ref_manual/IMX6DQ...
Or, in the case of more generic micro-based systems like an Arduino or something, you're reading datasheets for other little chips and figuring out how to interface them to your host's kernel.
But yeah, knowing how to wire up a transistor or LED to a processor without cooking it (or your power supply) is a good thing. You can learn a lot from taking apart other people's projects and seeing how they do it. Common patterns start showing up.
If you are specially interested in embedded programming, try to start using avr-gcc directly- you'll be forced to learn lot of low level stuff which is hidden by Arduino IDE.
I have an ISP and Arduino. I yanked the AVR chip off the Arduino and stuck it on a breadboard. I just found it difficult to do anything due to my lack of EE knowledge. I could understand the programming basics due to past experience, but had no clue what was going on under the hood.
I think I'll read that EE book and then continue on the path I'm on.
If not, well, you may need to learn assembly, C, or something else entirely (but probably not EE), and the experiment will help you discover what exactly you need.
One project that might help out is to re-write the 8150 USB network adapter project. The devices that have this chipset are easy and cheap to find and the data sheet is easily available. There's a PCI version of this chip, the 8139, too. The USB project would be easier since you're passing URBs back and forth. The LDD3 book and the data sheet is more or less all you need.
I'm wondering if I might be able to help out, but I'm not sure I understand the question. I'm an EE with a lot of digital design background and some software.
I have experience with C, but don't really know where to start with the lower level stuff.
I'm thinking I should start with a simple book like Electrical Engineering 101 (http://www.amazon.com/Electrical-Engineering-101-Third-Schoo...). Once I have a grasp on some EE basics I might be able to step into the Microprocessor programming a bit better, knowing a bit of what's happening behind the scenes.
Any thoughts/suggestions?