News for hackers. Stuff that matters.
Re:Designing Hardware for the Internet of Things by sparky on Saturday April 06, 2013 @04:30PM (#5504928)
FWIW, that image is a preview from the OSH Park ordering site[1]. I can highly recommend the service for prototype 2- and 4-layer boards. The price is right, the turnaround time and customer service are awesome, and the specs are better than anything else I've found in the price range. And they're purple.

[1] http://www.oshpark.com

Re:Designing Hardware for the Internet of Things by evck on Saturday April 06, 2013 @04:33PM (#5504940)
Yep, it's an OSHPark render. I'm not quite ready to release the design files, so I figured I'd post that picture since it's nice an purple.

I'd also recommend OSHPark.

Re:Designing Hardware for the Internet of Things by sparky on Saturday April 06, 2013 @04:39PM (#5504950)
Good luck with the waveguide! Have you done anything that high-speed with OSH Park before? I'm waiting on a PCIe board from them that I hope will do Gen3 speeds (8GHz) over 2.5-inch traces, but the lack of impedance control has me nervous.

I suppose the waveguide looks pretty short (under an inch?) so it might not matter much?

Re:Designing Hardware for the Internet of Things by evck on Saturday April 06, 2013 @04:50PM (#5505007)
Haven't done anything high speed, but I'm not too worried since it's short. It might not be perfect on the first run, but hopefully it'll work.

8 GHz and multiple traces would be a bit more concerning without impedance control. Hope it works out.

Re:Designing Hardware for the Internet of Things by sparky on Saturday April 06, 2013 @05:51PM (#5505185)
To be clear, my differential pairs are impedance controlled in the sense that their trace/space yield the correct single-ended and differential impedance values at the nominal dielectric permittivity and thickness, but OSH Park doesn't additionally guarantee permittivity and thickness tolerances to guarantee that my nominally-50-ohm traces will be actually-50-ohm traces +/- 10%. That said, I've run the numbers (using the excellent and free Saturn tools [1]) for the stated Er range of 4.2 +/- 0.3, and a little variation in the nominal 7.8 mil thickness, and things still looked OK.

Fingers crossed!

[1] http://www.saturnpcb.com/pcb_toolkit.htm