Re:German student builds electromagnetic harvester to rechar...
by bigiain on Sunday February 24, 2013 @07:31PM
(#5276662)
Think of it as a tremendously-inefficiently-magnetically-coupled transformer. The power line or wifi antenna is the "primary winding" and the antenna in this box is the "secondary winding" and the air in between them is doing an awful job of being the iron plates a normal transformer winds those wires around to direct and concentrate the magnetic fields. Power drawn out of the secondary coil results in power draw in te primary coil (multiplied by the inefficiency of the transformer). The reason this appears to work is that no-ones measuring the increased power draw from the source - since the device is only drawing microamps or possibly single digit milliamps at a volt or two, no power company is going to notice a few milliwatts of extra load.
On the other hand, if you stacked 20 or 30 of these around your ~100mW wifi basestation, where do you suppose the power extracted comes from (and, as you suggest,what do you suppose would happen to your wifi range? I also suspect loading up the transmitting antenna like that will change enough about the way the transmitter/antenna system works, and degrade the transmitter output in even more serious ways than just the raw power extracted might indicate - I'l guess the frequency and resonance assumptions made by the transmitter designer would all be wrong.)
On the other hand, if you stacked 20 or 30 of these around your ~100mW wifi basestation, where do you suppose the power extracted comes from (and, as you suggest,what do you suppose would happen to your wifi range? I also suspect loading up the transmitting antenna like that will change enough about the way the transmitter/antenna system works, and degrade the transmitter output in even more serious ways than just the raw power extracted might indicate - I'l guess the frequency and resonance assumptions made by the transmitter designer would all be wrong.)