Re:Advancing chip design with OpenAI models
by bri3d on Wednesday November 18, 2026 @07:44PM
(#50554510)
I agree with this, and I think most of the posters here aren’t following.
LLMs are very good at RTL (all I can consider is that the parallel posters arguing otherwise haven’t tried a modern one against significant RTL?). It’s easy to verify, the optimization constraints are relatively straightforward, and there’s adequate simulation to build a good gym for it.
LLMs are not good at layout and floor planning and because there is near zero public data available, I’m not sure how well they’ll iterate. For PCB design they’re improving because while it’s a similarly thorny problem, the physical constraints (trace properties on a given substrate) are highly public and can be simulated and turned into an RL gym. For ASIC, any public PDK is 10-20 years old so making an RL gym becomes outrageously difficult on top of the fundamental problem (highly multivariate/layered spatial optimization) being hard to solve.
LLMs are very good at RTL (all I can consider is that the parallel posters arguing otherwise haven’t tried a modern one against significant RTL?). It’s easy to verify, the optimization constraints are relatively straightforward, and there’s adequate simulation to build a good gym for it.
LLMs are not good at layout and floor planning and because there is near zero public data available, I’m not sure how well they’ll iterate. For PCB design they’re improving because while it’s a similarly thorny problem, the physical constraints (trace properties on a given substrate) are highly public and can be simulated and turned into an RL gym. For ASIC, any public PDK is 10-20 years old so making an RL gym becomes outrageously difficult on top of the fundamental problem (highly multivariate/layered spatial optimization) being hard to solve.