Re:Why Amstrad chose the 3" drives
by belviewreview on Friday November 06, 2026 @07:22PM
(#50400354)
My first computer was an Amstrad 8256 (also known as the Joyce). It came with a 3" drive. They worked ok but were expensive. After a while I installed a standard 3.5 " drive in the second drive slot. Besides being cheaper and much easier to obtain, they also had twice the capacity, as I recall. Over time I also installed a modem and replaced the 8 bit dot matrix printer with a 16 bit one.
[ Parent
| on HN ]
Re:Why Amstrad chose the 3" drives
by orangewindies on Wednesday November 11, 2026 @05:07AM
(#50451619)
Do you mean replacing the 9-pin dot matrix printer with a 24-pin one? 9 pins allowed printing a line of text with ascenders and descenders in one pass.
Re:Why Amstrad chose the 3" drives
by belviewreview on Wednesday November 11, 2026 @09:30PM
(#50462331)
Oh you're right, the original was 9 pin and the new one was 24. The new one made beautiful text, and besides that was much faster.
Re:Why Amstrad chose the 3" drives
by roryirvine on Thursday November 12, 2026 @05:01AM
(#50465179)
The 9 pin printer on the 8256/8512 was a great example of the Amstrad approach.
Mechanically, it was pretty good - albeit a bit slow and noisy. But it didn't have its own power supply or controller, so instead used the host computer for both. This cut costs, and enabled the PCW to do without proper serial or parallel ports which was yet another way that Amstrad managed to save money.
The upshot was that you could get full control over the stepper motor, allowing it to be driven in a '1 pin' mode which produced a single row of pixels at a time giving a much higher effective resolution. Some DTP packages like Microdesign II used it to good effect - I recall the results looking better than an Epson 24 pin, at the cost of taking something like 30 mins to print a single page!