News for hackers. Stuff that matters.
Re:Make the Metric system the standard in the United States by jacquesm on Wednesday January 02, 2013 @11:35AM (#4997464)
That would make good sense. What about things like wheel nuts, hitch attachements and so on?

The ford I had had a surprising amount of imperial on it about a decade ago. Presumably under the hood and inside the engine it was all metric though.

Re:Make the Metric system the standard in the United States by tadfisher on Wednesday January 02, 2013 @01:42PM (#4998354)
I daily-drive a 1997 Ford Ranger pickup. The engine was produced in Cologne, Germany, and thus everything under the hood is metric. The body & chassis was built in Dearborn, Michigan, and thus everything not under the hood is SAE.
Re:Make the Metric system the standard in the United States by jacquesm on Wednesday January 02, 2013 @02:01PM (#4998499)
That perfectly matches my Ford experience.
Re:Make the Metric system the standard in the United States by VLM on Wednesday January 02, 2013 @01:40PM (#4998335)
"What about things like wheel nuts"

I can verify its 30 mm with my wheels/hubs on my car. Supposedly that's "unusual" and most cars that size are 28mm or 32mm so people end up mystified why their 28 doesn't fit something that looks visually at a distance like a 28, or they use a way too big 32 and neatly round off the corners of the nut when it slips. I imagine using an imperial impact wrench is an effective way to round off the wheel nuts on a Saturn.

I would imagine if you bought aftermarket wheels/studs alloy or steel you could have most any size within a narrow range that's compatible with the hub.

"hitch"

LOL at the idea of my tiny little 2-door subcompact towing anything like those giant RV trailers. I do know standard american trailer hitch on pickup trucks has been 2 inch square for a century or something like that. Kind of like how we're not going to change every piece of railroad track and rolling stock in the USA to a metric equivalent rail gauge any time soon, until the end of time we'll be stuck with 50.8mm trailer hitches. I bet you could slam a european 50mm in the hole within manufacturing/rust tolerances.

Re:Make the Metric system the standard in the United States by benjohnson on Wednesday January 02, 2013 @01:57PM (#4998473)
32mm is used all over in GM world - 32 just happens to be barely smaller that 1 1/4" inches so it keeps people that only have SAE sockets happy. 1
Re:Make the Metric system the standard in the United States by jcoby on Wednesday January 02, 2013 @03:07PM (#4998931)
Completely depends on the car. Wife has a 2006 Mariner, it has 19mm wheel nuts. My '91 Explorer is 5/8" or 9/16" or so (I don't remember). I also have a BMW that's 100% metric of course. And a '68 mustang that's 100% SAE.

The explorer is metric in a lot of places. The engine is SAE since it's based on the 302 which was originally designed in the early '60s. Pretty much anything that was designed from the mid 80s or later will be 100% metric hardware unless it needs to work with something that isn't. And even then it'll will sometimes be metric until it hits the non-metric piece. For example, the Tremec T-5 transmission is metric but mates up to the Ford 302 which is SAE.

So basically, it's usually metric except when it's not.