Re:Print with dozens of colors: Our new open-source ColorMix...
by naasking on Saturday May 30, 2026 @10:33AM
(#48336657)
> the simplest is just mixing filaments, like one mixes paint. The article doesn't spell out the reason it doesn't work, I am curious as to why.
Plastic flow is laminar, where colour mixing requires turbulence. If you make a turbulent nozzle, it's basically impossible to print reliably with it (the pressure used to push filament out of the nozzle is mostly absorbed/redirect into turbulence).
Re:Print with dozens of colors: Our new open-source ColorMix...
by MayeulC on Tuesday June 02, 2026 @04:32AM
(#48367512)
Thank you for the clear & concise answer. A rotating nozzle and/or alternating colors might work then, but that would be a relatively complex engineering project.
Plastic flow is laminar, where colour mixing requires turbulence. If you make a turbulent nozzle, it's basically impossible to print reliably with it (the pressure used to push filament out of the nozzle is mostly absorbed/redirect into turbulence).