Re:Invisalign Became the Biggest User of 3D Printers
by roughly on Saturday March 21, 2026 @03:40PM
(#47470511)
As the joke goes, $10 to tighten the bolt, $90 to know which bolt to tighten.
Re:Invisalign Became the Biggest User of 3D Printers
by joe_mamba on Saturday March 21, 2026 @02:35PM
(#47469897)
>The difficult part is not the manufacturing, but knowing how to do it properly so you don’t harm the patient.
And yet I read plenty of horror stories of bad orthodontic results. Ask me how I know.
Went to 3 different orthodontist to fix what a bad orthodontist did to me when I was a kid, and each gave me a completely different treatment plan. I feel like being an orthodontist is just eyeballing and patching your way as you go to an acceptable resolution.
Re:Invisalign Became the Biggest User of 3D Printers
by jmalicki on Saturday March 21, 2026 @03:26PM
(#47470395)
Given that, shouldn't you be even more concerned about people YOLOing it, if even highly trained orthodontists are regularly screwing this up?
Re:Invisalign Became the Biggest User of 3D Printers
by joe_mamba on Sunday March 22, 2026 @11:04AM
(#47478272)
Absolutely. I'm sure some high-IQ high-functioning autists like John Carmack or Palmer Luckey could fix their teeth at home with some alligners they 3d printed in their garage better than a sloppy orthodontist, but that obviously doesn't scale to gen-pop.
Re:Invisalign Became the Biggest User of 3D Printers
by jmalicki on Sunday March 22, 2026 @02:41PM
(#47480667)
It's not even just 3d printing skill, but understanding the physiology of how the bone and teeth will restructure themselves over time to know the right amount of pressure to apply to encourage that remodeling, without so much pressure to cause damage - there is a huge amount of scientific research there! (That I'm sure some orthodontists probably pay more detailed attention to than others).
I don't doubt a high-IQ high functioning autist could self-teach this, but there's a ton of background there.
Re:Invisalign Became the Biggest User of 3D Printers
by hattmall on Saturday March 21, 2026 @05:15PM
(#47471464)
Sure, but it's a more or less a formulaic process. There's not on the fly decision making or emergency responses like in orthopaedic surgery or any other surgical design. You make a mold or scan of teeth. Calculate the adjustments, make the retainer, repeat. With a more widely available tooling the process could be even more monitored. i.e. Bi-weekly instead of monthly molds for faster and more precise results.
The difficult part is not the manufacturing, but knowing how to do it properly so you don’t harm the patient.