News for hackers. Stuff that matters.
Re:The Hidden Engineering of Runways by Animats on Monday January 26, 2026 @05:30PM (#46772510)
Here's the one-minute version from the FAA.[1]

Runway overrun areas marked with diagonal stripes have an Engineered Materials Arresting System. There are several different materials used. One is pumice embedded in styrofoam, with a thin concrete layer on top. Large aircraft weigh enough to break through, and the pumice is crushed to powder, absorbing energy. This yields a surprisingly short stopping distance. The aircraft landing gear will be damaged, but the rest of the aircraft is usually intact. The overrun material comes in prebuilt blocks, and after an overrun, only the ones damaged need to be replaced.

It gets a lot of use. The FAA has logged 25 overruns stopped by EMAS, out of 161 runway ends so equipped. That's surprisingly high.

It's a simple, clever system.

[1] https://www.youtube.com/watch?v=hVSvU06_NGE

Re:The Hidden Engineering of Runways by mrexroad on Monday January 26, 2026 @08:16PM (#46774214)
That’s pretty cool. I’d assumed there would be something similar to the run-away truck ramps you see on steep grades — basically a deep gravel pit. However, actually thinking about it, something along the lines of a gravel pit would likely cause significant damage to engines (not to mention risks created by engine damage) but also seriously impede emergency services.
Re:The Hidden Engineering of Runways by Animats on Monday January 26, 2026 @10:13PM (#46775057)
These overrun areas aren't that long. This trick is used where there's not enough room for a long overrun area. The high drag has to start fast. With the styrofoam/pumice material, the wheels quickly drop all the way to the hard bottom of the arresting material, and then plow forward, dissipating energy by crushing pumice. With something more solid, the wheels may skim the surface for a while before digging in.
Re:The Hidden Engineering of Runways by marcosdumay on Monday January 26, 2026 @08:32PM (#46774350)
Gravel flies. You can't have it anywhere near an airport runway.

(Some planes have no problem with it, though. You can make even the entire runway of gravel if you only fly those.)

Re:The Hidden Engineering of Runways by andkenneth on Monday January 26, 2026 @10:26PM (#46775153)
the distinction here is mainly jets vs props.
Re:The Hidden Engineering of Runways by stackghost on Tuesday January 27, 2026 @12:21AM (#46775849)
Gravel will happily fuck up a prop just as much as a turbine; it's more about ground clearance. The engines on modern airliners are quite low to the ground, which is why they tend to ingest gravel kicked up by the nose gear.
Re:The Hidden Engineering of Runways by CGMthrowaway on Tuesday January 27, 2026 @10:15AM (#46781072)
What's the ground clearance of a flying piece of gravel! (in a gust of wind for example)
Re:The Hidden Engineering of Runways by stackghost on Tuesday January 27, 2026 @01:15PM (#46783965)
>What's the ground clearance of a flying piece of gravel! (in a gust of wind for example)

I'm not sure I understand the question you're asking. "Ground clearance" refers to the space between the thing and the ground. Airliners are low-wing monoplanes with the engines slung underneath the wings, and aft of the nose landing gear. The tires at the nose can kick up gravel which not only dings up the underside of the fuselage but can also get sucked into the jet intakes. There's only about 2 feet of clearance between the engine cowling and the ground.

Compare this to a C-130 Hercules which is a high-wing monoplane with turboprops, which is designed to handle some degree of unprepared surfaces. The prop tips are never less than about 5 feet from the ground.

Or, compare to a Piper Cub which has much less prop ground clearance but has the prop mounted forward of the nose landing gear so it's much less likely to encounter gravel.

"What is the ground clearance of a flying piece of gravel" is... not really a question that makes sense to me.

Re:The Hidden Engineering of Runways by spockz on Tuesday January 27, 2026 @01:57PM (#46784576)
I expect that “How high does a pebble get clear of the ground?” is what they meant to say afaict.
Re:The Hidden Engineering of Runways by CGMthrowaway on Tuesday January 27, 2026 @05:41PM (#46788167)
"gust of wind"

flying gravel not limited to nosewheel kicks

Re:The Hidden Engineering of Runways by hobofan on Monday January 26, 2026 @05:37PM (#46772609)
That's only a small portion of what the video is about.
Re:The Hidden Engineering of Runways by horsawlarway on Tuesday January 27, 2026 @01:34PM (#46784248)
Honestly - the video barely touches on this at all, despite making it the "hook".

I was pretty disappointed that he doesn't discuss the EMAS mechanics, structure, actual stopping distance, or impact to the plane in nearly any real way.

He does show a LOT of animation of layered runways, which are mostly not that informative.

There is some decent discussion around maintenance and material choice, and some very basic discussion of infrastructure requirements outside of the runways themselves that's... ok.

Overall... I thought this was a solid C+ video. It shows planes plowing into an EMAS, then does jack all to discuss that, while bringing up a lot of less interesting discussion of runway building (which despite the claims in the video, do actually correspond very highly to how we build highways, just with different weight/maintenance requirements.)

Re:The Hidden Engineering of Runways by ash_091 on Tuesday January 27, 2026 @03:21PM (#46785948)
I don’t think anything you said is wrong, but I do think you’re misreading the intent of the channel.

Practical Engineering is very deliberately framed as edutainment. The animations, pacing, and level of depth are conscious choices meant to keep non-specialists engaged rather than to maximize technical rigor.

In that sense, it belongs alongside other popular "science-y" channels like Kurzgesagt, Vsauce, and Technology Connections: content that prioritizes narrative and engagement over completeness or instruction.

The target audience is the broad middle of the technical bell curve. Animations of runway layers may make the video less appealing to you, but more accessible to a much larger, less technical audience.

Different goals imply different success criteria. If the goal is reach rather than comprehensive education, a million views in seven days looks like success.

Re:The Hidden Engineering of Runways by kmarc on Tuesday January 27, 2026 @02:26AM (#46776566)
Hah, I guess this is the same then as in formula 1 (and possibly other motorsports). After the end of a straight (speeding) section, just before the curve they have 150/100/50 (m?) distance indicators. Sans the concrete block at the top. That would obviously shave the driver's head off.

When a driver hits these, they evaporate as dust.

Re:The Hidden Engineering of Runways by bonzog on Tuesday January 27, 2026 @08:08AM (#46779469)
It's not quite the same thing - the EMAS is the overrun surface itself, rather than the signs warning of it. However you are quite close to the money on another aspect of airfield design.

Lots of obstructions near the runway - signs, lights, aerial masts, meteorological equipment, fences - are supposed to be "frangible" [1]. They must break into pieces less likely to cause damage to an aircraft in a high-energy collision. There's a heck of a lot of GFRP used in lieu of metal around an airfield.

1. ICAO Doc 9157, particularly part 6.

Re:The Hidden Engineering of Runways by Night_Thastus on Tuesday January 27, 2026 @01:05PM (#46783800)
EMAS is going to save a LOT of lives in the long run. It's consistently effective at its job. I'm very excited to see it more widespread.