Re:Plane crashed after 3D-printed part collapsed
by jandrese on Thursday December 04, 2025 @04:25PM
(#46153305)
> The epoxy resin specified for the laminate has a glass transition temperature of 84°C
This seems very low for the kinds of epoxy I've used. I wonder if the manufacturer specs are highly conservative? Or maybe the material has a shortened lifespan with even moderate temperatures?
I was thinking about the ABS in the article and wondering if I would have made the same mistake. Close to every car manufactured today has plastic intakes, usually bolted right on top of the engine. The incoming air should help keep it cool, especially on aircraft. Maybe it was the radiant heat from a nearby cylinder that melted it?
Re:Plane crashed after 3D-printed part collapsed
by CarVac on Thursday December 04, 2025 @04:29PM
(#46153360)
There are some incredibly low Tg epoxies out there, such as West Systems 105 where "TG onset" is 54°C and the heat deflection temperature is even lower.
This seems very low for the kinds of epoxy I've used. I wonder if the manufacturer specs are highly conservative? Or maybe the material has a shortened lifespan with even moderate temperatures?
I was thinking about the ABS in the article and wondering if I would have made the same mistake. Close to every car manufactured today has plastic intakes, usually bolted right on top of the engine. The incoming air should help keep it cool, especially on aircraft. Maybe it was the radiant heat from a nearby cylinder that melted it?