Re:Blender 5.0
by blacklion on Wednesday November 19, 2025 @06:38AM
(#45978361)
KiCAD becomes better and better, but one limitation embedded into its DNA is very annoying: one project - one schematic - one PCB.
It is very kludgy and cumbersome to split project into several PCB (for example, stack of PCBs connected by backplane or headers, like Arduino & Shield for it) and/or to have variations of the PCBs for one schematics, like TH and SMD variants of the PCB for exactly same schematics.
Even in my very modest almost-electrical (as opposed to electronic) projects I need one or another from time to time.
As far as I understand it is limitation which is not easy to fix, because all architecture of KiCAD is based on this 1-1-1 principle.
Re:Blender 5.0
by abrugsch on Wednesday November 19, 2025 @06:43AM
(#45978405)
My workaround for multiple PCB's for one schematic is to have the schematic as a top level sheet which can then be imported into sub-level projects. so each PCB becomes it's own project but use the common schematic sheet
It is very kludgy and cumbersome to split project into several PCB (for example, stack of PCBs connected by backplane or headers, like Arduino & Shield for it) and/or to have variations of the PCBs for one schematics, like TH and SMD variants of the PCB for exactly same schematics.
Even in my very modest almost-electrical (as opposed to electronic) projects I need one or another from time to time.
As far as I understand it is limitation which is not easy to fix, because all architecture of KiCAD is based on this 1-1-1 principle.