When I want to do FPGA, I start with an IceStick or BlackIce board (Lattice ICE40 FPGA). But then it comes down to interfacing it to some other chip. So if I make a little PCB that needs more than 16 I/O pins at the edge, I've got myself into extra ribbon cable to jumper to more I/Os..
I even made one wire-wrap board with 4 socketed 74LVC245 level shifters that the BlackIce board would plug into. From there, I could do what I wanted.
I agree that damaging your wires is a serious risk. I guess I'm lucky that this never derailed me. I follow the color rule: blue on the bottom layer, yellow on the second. No daisy chains! Rather than unwrapping to get to a hidden blue wire, I can just cut it.
Also I should mention that I'm not doing anything above 25 MHz.
Thank you for the explanation and much good luck with your projects.
As for cold solder joints: no, they don't do that. But when you start making modifications you have to be extremely careful not to cause any damage because tracing a loose joint on a wire wrap board is the stuff of nightmares.