Re:Seattle Ultrasonics: Ultrasonic Chef's Knife
by karmanGO on Saturday September 20, 2025 @02:44PM
(#45316093)
The battery is comes out for recharging, so replacing a dead battery should be trivial
[ Parent
| on HN ]
Re:Seattle Ultrasonics: Ultrasonic Chef's Knife
by scrlk on Saturday September 20, 2025 @02:53PM
(#45316188)
It's a proprietary form factor, so you're gambling on replacements being available down the line. I don't think it'll be easy to rebuild the battery pack without compromising the casing.
Re:Seattle Ultrasonics: Ultrasonic Chef's Knife
by Zak on Saturday September 20, 2025 @03:02PM
(#45316276)
Given the battery specs and the form factor of the products, they could have used a 14500 cell that retails for $5. That's not as much recurring revenue as charging $80 for something proprietary though.
Re:Seattle Ultrasonics: Ultrasonic Chef's Knife
by ReptileMan on Saturday September 20, 2025 @04:45PM
(#45317330)
3d printer and couple of cells and I guess a board will get the job done.
Re:Seattle Ultrasonics: Ultrasonic Chef's Knife
by xxs on Saturday September 20, 2025 @06:29PM
(#45318182)
You will have to print it from something like polyamide or polycarbonate, definitely not PLA
Re:Seattle Ultrasonics: Ultrasonic Chef's Knife
by aembleton on Saturday September 20, 2025 @05:21PM
(#45317672)
Or chuck it out as e-waste and buy the shiny new one
Re:Seattle Ultrasonics: Ultrasonic Chef's Knife
by prmoustache on Saturday September 20, 2025 @05:08PM
(#45317569)
The dead battery is still e-waste and recycling isn't a magically neutral activity that brings back one new product out of an old one with no loss or energy spent.