News for hackers. Stuff that matters.
Re:%CPU Utilization Is a Lie by hinkley on Tuesday September 02, 2025 @08:48PM (#45111033)
That's likely the primary factor, but then there's thermal throttling as well. You can't run all of the logic units flat out on a bunch of models of CPU.
Re:%CPU Utilization Is a Lie by tgma on Tuesday September 02, 2025 @08:56PM (#45111099)
May be true for FMA or AVX2 or similar stuff. Outside vector units that sounds implausible. Obviously multi core thermal throttling is a thing but that would by far dominate. Hyperthreading should have minimal impact there.
Re:%CPU Utilization Is a Lie by gruez on Tuesday September 02, 2025 @08:54PM (#45111082)
>but then there's thermal throttling as well. You can't run all of the logic units flat out on a bunch of models of CPU.

That doesn't make any sense. Disabling SMT likely saves negligible amount of power, but disables any performance to be gained from the other thread. If there's thermal budget available, it's better to spend it by shoving more work onto the second thread than to leave it disabled. If anything, due to voltage/frequency curves, it might even be better to run your CPU at lower clocks but with SMT enabled to make up for it (assuming it's amenable to your workloads), than it is to run with SMT disabled.