News for hackers. Stuff that matters.
Re:Isle FPGA Computer: creating a simple, open, modern computer by jecel on Saturday August 09, 2025 @06:02PM (#44850710)
Though DVI/HDMI monitors are supposed to handle 640x480, over half of the ones I have tested don't display anything. Every single one of them worked just fine at 1280x768, however, so I am changing my projects to use that.
Re:Isle FPGA Computer: creating a simple, open, modern computer by mercnz on Saturday August 09, 2025 @11:05PM (#44852482)
did you try at 60hz? i've found a lot of monitors don't like 70mhz 720x400.. which is what bios often boots to on older computers. i'm not sure if they're running 640x480 at high refresh rate too.
Re:Isle FPGA Computer: creating a simple, open, modern computer by jecel on Tuesday August 12, 2025 @05:52PM (#44882207)
Yes, I only tested the 60Hz vertical refresh options.
Re:Isle FPGA Computer: creating a simple, open, modern computer by WillFlux on Sunday August 10, 2025 @03:44AM (#44853518)
I'm surprised by this. 1280x768 is an unusual resolution, what display timings are you using?

I've found 1024x768 and 1280x720 are both well supported. I tend to use these display timings: https://projectf.io/posts/video-timings-vga-720p-1080p/

Re:Isle FPGA Computer: creating a simple, open, modern computer by jecel on Tuesday August 12, 2025 @05:51PM (#44882204)
Thanks for the link. I meant to write 1280x720@60Hz for 16:9 HDMI TVs/monitors but have used 1024x768 quite a bit in the past for 4:3 VGA monitors and ended up mixing the two.

VIDEO_ID_CODE 4 (1280x720) works on all monitors I tested while 1 (640x480) only displays on half of them:

https://github.com/nand2mario/nestang/blob/master/src/hdmi2/...