A bit half-assed, wouldn't you say?
I enjoy hand-crafting small circuits but am glad to use my cell phone to take a picture of the result. I love riding a bicycle but use a car to go 30 miles when needed. There is no contradiction to be had here. Just different purposes.
Sometimes simple joy is the priority.
I'm perhaps not quite so distracted by a well rounded fillet in a cast iron or steel body as you appear to be!
I love all materials and the ingenious ways we have found to fashion those materials. I only recently bought a router because I had to cut a wide and deep rebate in a door to fit a finger handle. Doing that with chisels is possible but a bloody nightmare. An over enthusiastic wack or allowing the grain to take over too much would have needed a potentially ugly repair.
I speak en_GB so when I say router (spinning power tool) and router (IP packet shuffler) they sound different.
I've just taken a look at that page you linked and may have to dump my browser cache and try and forget where I saw the link ... 8)
The moulding plane book I linked really opened my eyes to creating profiles. I’ve had to match multiple non standard profiles cut into different mouldings, window sashes, mutton bars, etc in the old house I live in, and that would be impossible without cutting a custom profile for a shaper. Seems like a huge waste of effort to cut a tool steel profile for a one off when I can just grab a couple hollows and rounds and make literally anything.
Check out the maker of HNT Gordon using his planes. https://youtu.be/fHsEjiXv0c4?si=jyXdUilNnCtH7Xci
He actually has a different technique than the one in the moulding plane book I linked, and I like the book technique a lot more. It’s foolproof