Open Hardware Ethernet Switch project, part 1

Re:Open Hardware Ethernet Switch project, part 1 by jmcguckin on Tuesday May 13, 2025 @06:23AM (#43971415)

If i wanted to do a motherboard that held 16 or 24 raspberry-pi compute modules, could i connect them together using the onboard gig ethernet without using any magnetics? Just by using the gige output from the module going to a commercial switch chip.

[ Parent | on HN ]

Re:Open Hardware Ethernet Switch project, part 1 by fxtentacle on Tuesday May 13, 2025 @06:28AM (#43971445)

In general, that should work. Here's an example board with 4x CM4 modules and a RTL8367N switching chip: https://github.com/will127534/Miniature-CM4-Cluster

[ Parent | on HN ]

Re:Open Hardware Ethernet Switch project, part 1 by azonenberg on Tuesday May 13, 2025 @06:37AM (#43971493)

You're going to at least want to AC couple through some capacitors to avoid problems with common mode / RX bias issues between the different PHYs. But if it's on-mobo you don't need to have as much of a fault voltage rating compared to standard Ethernet which IIRC specs 1 kV isolation on the transformers.

[ Parent | on HN ]