News for hackers. Stuff that matters.
Re:Booting the RP2350 from UART by gadgetoid on Monday May 12, 2025 @04:30AM (#43960797)
We (Pimoroni) actually shipped this technique in PicoVision, used to load the “GPU” firmware (an RP2040 used to offload the HDMI signal generation) at runtime-

https://github.com/pimoroni/picovision/blob/main/drivers/dv_...

Re:Booting the RP2350 from UART by no_time on Monday May 12, 2025 @08:51AM (#43962355)
What are the advantages of doing this instead booting it through UART? Speed perhaps?
Re:Booting the RP2350 from UART by vardump on Monday May 12, 2025 @09:15AM (#43962555)
I think RP2040 does not support UART booting.
Re:Booting the RP2350 from UART by gadgetoid on Monday May 12, 2025 @03:16PM (#43966562)
In theory you wouldn’t even need to load firmware- you could just manipulate the relevant registers directly over SWD for the silliest IO expander.

In our case it was the only choice. I’d say we’d use UART now but the RP2350 can pretty much do it all in one chip.