The heat exchanger point is interesting. However doesn't stainless already lose out to 3D printed aluminum for the sort of applications where the optimization is worth the cost? This material is even heaver than steel and substantially more expensive.
It's tangential but I wonder how amenable to 3D printing this material will prove to be.
High-energy cryogenic ball milling of 10 grams for four hours in a continuous flow of liquid nitrogen under an argon atmosphere with <1ppm oxygen (https://www.science.org/action/downloadSupplement?doi=10.112...) sounds expensive, but maybe they only did it that way because it was a low-risk way to ensure the alloying worked with the lab equipment they had on hand, not because it's the cheapest way to make the material. Hopefully cheaper ways are found.
I'm no expert in heat exchangers, but my calculations suggest 3-D printing is or will be an enormous boost there, and may reverse the gradient of merit for wall material thermal conductivity, favoring good thermal insulators over good thermal conductors like copper and aluminum. As for aluminum, it is only suitable for low temperatures.
I'm curious. What mechanism would lead to an insulator being favored in a heat exchanger?
Fair point about aluminum and temperature. As a layman an engine block is high temperature to me. I guess this would be extremely useful for more exotic stuff.
I could be wrong about this, but I didn't just make it up; I got it from Lingai Luo's book on heat and mass transfer intensification, which hopefully I've understood correctly.
With 3D printing I wonder if you could insert bands of insulator into an otherwise conductive wall? But you're dealing with large (potentially ridiculously so) temperature ranges so I wonder if it would prove difficult to match the thermal properties of the two materials closely enough.
I now have the weirdest desire to play with heat exchanger designs that I have absolutely zero use for. I've been nerd sniped.
As for water tanks, regulating temperature is not always "easy", and a major reason copper is used for water pipes is its great resistance to corrosion. In this case apparently it will be more expensive than the same mass of stainless, but it's apparently also stronger than stainless, so maybe you can use less of it, making it cheaper again.