Except for the drive killed by the dropped manual, that's essentially what happened to the others—about a dozen or so. They just stopped working, either they wouldn't start on boot or they'd just become inaccessible during operation. I wasn't alone, others I know had the same issues. They were an unmitigated disaster, it beats me how they ever made it to market. (All were replaced under warranty with other brands.) BTW, I never lost any data as I used Tandberg QIC tape streamers for backups.
Incidentally, the drive killed by the manual was only 20MB. If I recall correctly the largest Connor drive I used was only 40MB.
Did you ever attempt to recover the data from that drive by way of a data recovery service or such?
Also: the drive was absolutely dead, it wouldn't power up. I even tried to change its controller - I took it off another Conner drive, installed it on the deceased one - and nothing happened. On that occasion I realized that, even though they were the same model/capacity, Conner had used different electronics for different batches.
Ironically, the drive was built like a tank: never again I saw a hard-drive with a casing that thick (looked like cast iron).
https://wiki.preterhuman.net/Conner_Peripherals
You might be thinking of Terminator ...?
Right, perhaps the name ought to be Data Terminator. :-)
Never have I experienced worse drives than those made by Connor Peripherals Inc. I've had them fail on many occasions—they'd fail if so much as to look at them.
I recall one instance where I'd spent hours setting up my computer and all was OK only to drop a small manual onto the table from a few inches height. The next thing that happened was the OS chucked an 'Abort, Retry or Ignore' message. Drive was completely dead.