News for hackers. Stuff that matters.
Re:With Core One, Prusa's Open Source Hardware Dream Dies by Miraste on Wednesday November 20, 2024 @05:20PM (#42198729)
What printing surface are you using? I use a PEI sheet that I clean with straight isopropyl alcohol, and I almost never have issues.
Re:With Core One, Prusa's Open Source Hardware Dream Dies by kiba on Wednesday November 20, 2024 @05:26PM (#42198769)
PEI smooth and textured. Isopropyl alcohol works until it doesn't. That is why it is recommended that you use warm water with soap. I suspect the ratio of water to soap isn't dialed in quite right in my case, but I haven't bother to fix it just yet.

Either that, or don't touch the surface with your bare hands.

Re:With Core One, Prusa's Open Source Hardware Dream Dies by Miraste on Wednesday November 20, 2024 @05:33PM (#42198839)
I can only speak anecdotally, but I've been using this sheet for ~4 years while only cleaning it with 90+% IPA, and I haven't seen any loss of adhesion. I expect to replace it due to scratches before I have any problems with the cleaning method.
Re:With Core One, Prusa's Open Source Hardware Dream Dies by gerdesj on Wednesday November 20, 2024 @05:30PM (#42198807)
I always use IPA to clean the bed too.

I have once used glue for a very thin print with lots of intricate holes in it.

Re:With Core One, Prusa's Open Source Hardware Dream Dies by wisenull on Thursday November 21, 2024 @04:53AM (#42202651)
I think the problems arise from using glue on it.

If I only print PLA without glue, one wipe with IPA and it's clean.

Glue on the other hand, it really sticks and you need water and soap.