News for hackers. Stuff that matters.
Re:OpenSCAD: The Programmer's Solid 3D CAD Modeller by WillAdams on Saturday September 14, 2024 @08:28PM (#41544165)
One notable new development is the Python-enabled OpenPythonSCAD:

https://pythonscad.org/

which finally made it possible for me to finally have the ability to write out G-code (allowing one to use OpenSCAD as a CAM tool) and DXFs (allowing one to have fully control and to create not-closed/unconnected geometry, and to write out arcs rather than only polylines):

https://github.com/WillAdams/gcodepreview

For the current state see the latest preview of the current unit test:

https://forum.makerforums.info/uploads/default/original/3X/1...

Re:OpenSCAD: The Programmer's Solid 3D CAD Modeller by wiw2 on Saturday September 14, 2024 @09:46PM (#41544560)
Thank you! I have seen your posts in the PythonSCAD subreddit. They have been very helpful!
Re:OpenSCAD: The Programmer's Solid 3D CAD Modeller by WillAdams on Saturday September 14, 2024 @10:08PM (#41544650)
My pleasure!

I just hope we can get more folks using PythonOpenSCAD (or ideally, get it merged into the main branch).

Just finished up unit tests for the current state of gcodepreview:

https://raw.githubusercontent.com/WillAdams/gcodepreview/mai...

as part of my reading https://www.goodreads.com/book/show/39996759-a-philosophy-of... and applying what I learn from each chapter to it --- a bit more than a third of the way through, and it has already helped immeasurably.