Show HN: iFixit created a new USB-C, repairable soldering system

Re:Show HN: iFixit created a new USB-C, repairable soldering... by blahlabs on Thursday September 12, 2024 @07:19PM (#41526664)

When I first bought mine I tried to adjust the temperature in what felt like the natural way to do so, without rtfm first of course.

Then I quickly learned that I had adjusted the temperature calibration. I reverted what I had done but now I am not confident about the temperature its operating at, at all. Seems a terrible interface design.

[ Parent | on HN ]

Re:Show HN: iFixit created a new USB-C, repairable soldering... by XorNot on Thursday September 12, 2024 @08:24PM (#41527029)

Yep I did that too.

I recalibrated by using the thermocouple on my multimeter.

That's not my biggest problem though - my biggest problem has just been keeping tips tinned properly. I've succeeded once, but it constantly feels like a struggle.

[ Parent | on HN ]

Re:Show HN: iFixit created a new USB-C, repairable soldering... by pkolaczk on Friday September 13, 2024 @03:26AM (#41528837)

I found that brass wool works better at keeping tips tinned. A sponge removes all the solder and you have to quickly tin the tip immediately after wiping, otherwise it oxidizes. Wiping with brass wool leaves a thin layer of solder on the tip.

Also keeping the tip at moderate temperature range helps avoid oxidation - most manufacturers recommend to never exceed 400 C. JBC recommends to not exceed 370 C.

Hope this helps.

[ Parent | on HN ]