Show HN: Open-Source Software for Designing 3D-Printable Luneburg Lenses for RF

Re:Show HN: Open-Source Software for Designing 3D-Printable ... by jboirazian on Monday September 02, 2024 @12:42PM (#41426860)

Hi mikewarot,

As a general rule, Luneburg lenses need to have a diameter at least equal to the wavelength of the frequency they are designed to operate with. Because of this, Luneburg lenses are more cost-effective at higher frequencies, making them particularly suitable for applications in the GHz range.

It is possible to develop a Luneburg lens for LoRaWAN, and I am currently working on a DRC check for various wavelengths

[ Parent | on HN ]

Re:Show HN: Open-Source Software for Designing 3D-Printable ... by dbcurtis on Monday September 02, 2024 @02:21PM (#41427646)

Ah, so my dream of a compact beam for the 1.8MHz band still eludes me... :)

[ Parent | on HN ]

Re:Show HN: Open-Source Software for Designing 3D-Printable ... by mikewarot on Monday September 02, 2024 @04:30PM (#41428555)

You just need a mile or two of wire and a bunch of stakes with an open prarie for a rhombus antenna. ;-)

A roll of wire isn't very big ;-)

[ Parent | on HN ]