Re:Workmanship standard for crimping, interconnecting cables...
by analog31 on Sunday June 02, 2024 @04:12PM
(#40556902)
One useful property is that when partially tightened, they allow slight re-positioning of an assembly, before driving the fastener all the way home. In other words, they're actually used as springs.
Re:Workmanship standard for crimping, interconnecting cables...
by petee on Sunday June 02, 2024 @04:00PM
(#40556826)
Someone on YT did a demonstration on a paint shaker, and the bolts loosen nearly as fast as having none. Internal/external tooth washers or nylocks are the way to go
Re:Workmanship standard for crimping, interconnecting cables...
by cuSetanta on Sunday June 02, 2024 @06:43PM
(#40557704)
Nordlock washers are the best, but they are expensive and a little space inefficient.
Re:Workmanship standard for crimping, interconnecting cables...
by perihelions on Sunday June 02, 2024 @08:06PM
(#40558141)
(OCR error: s/brome/bronze/. Just pointing this out as a warning because I read it literally, and was very confused and spent some time search querying silly things).
In particular
>Lockwashers The typical helical spring washer shown in figure 14 is made of slightly trapezoidal wire formed into a helix of one coil so that the free height is approximately twice the thickness of the washer cross section. They are usually made of hardened carbon steel, but they are also available in aluminum, silicon, brome, phosphor-bronze, stainless steel, and K-Monel. The lockwasher serves as a spring while the bolt is being tightened. However, the washer is normally flat by the time the bolt is fully torqued. At this time it is equivalent to a solid flat washer, and its locking ability is nonexistent. In summary, a lockwasher of this type is useless for locking.