Perhaps not, but a lot of cameras already have it for geotagging purposes (EXIF), so why not use it:
* https://en.wikipedia.org/wiki/List_of_cameras_which_provide_...
* https://www.digitalcameraworld.com/buying-guides/best-camera...
Simply using the accelerometers and gyro directly does give the info you want. GPS is useless.
I think you may be confusing two concepts: Measurement of true north and latitude via gyro (what the GP is talking about) and inertial navigation systems (which, yes, do drift).
You can measure those two things with just a single-axis gyro and no external references using a technique called "gyro-compassing". In fact, most internal navigation systems use gyro-compassing to directly measure true north and latitude to align the system on initial startup.
Inertial measurement units for aircrafts and submarines cost as much as a house in California. Good luck putting those in a phone.
We have, naturally, also made better IMUs for places where it matters, ones which won't fit in your phone.
The question is therefore not suited to "aircraft grade, yes or no?", it's "how expensive is the cheapest IMU that's good enough for the specific need?" which in this case itself depends on how many stops is desired.
There pretty excellent if you keep them on a shelf bit if you run around outside in the hot and cold (you know, like people use a watch) they'll deviate quickly. Because they don't have a temperature controlled (or even compensated) oscillator. A real TXCO (basically putting the crystal inside a temp calibrated oven) is not feasible on a watch battery but compensation sure would be.
Nitpick: You're thinking about OCXO for crystals inside an oven, TCXOs are temperature compensated crystal oscillators
MEMS gyros have too much bias drift (both on a unit basis due to fab processes and on a temperature basis) to be practically useful here. You can measure the earth's rotation with a MEMS gyro, but you're really at the limit.
Worked makes it seem like you throw a switch and it just gives you position data. Those units take anywhere from 6 to 10 minutes to align, if you move the platform, it will error out and you must restart the alignment. The current systems take their initial fix from GPS, but the initial systems, the operator had to manually know and then key that information into the unit.
"Worked" with extreme care operated by a qualified professional.
It helps to have a rough indication of the current latitude on startup, but you can also figure it out from the gyro outputs. Just takes longer.
With modern sensors (solid state laser gyroscopes) it has all become a lot smaller so if you really want to you can do this in a camera. It's just probably going to be too expensive for what it brings, because 6+ stops of stabilisation is a lot already.