Re:A malicious vehicle can block "smart" intersections in th...
by bagels on Wednesday May 15, 2024 @12:15AM
(#40363041)
I always stopped out in front of the line, and gestured for the car to move up to trip the sensor for lights like this.
Re:A malicious vehicle can block "smart" intersections in th...
by imp0cat on Wednesday May 15, 2024 @01:40AM
(#40363465)
It's also usually possible to trigger the green light by using the button that is at the crosswalk (inteded to be used by pedestrians when they need to cross).
Re:A malicious vehicle can block "smart" intersections in th...
by prmoustache on Wednesday May 15, 2024 @03:42AM
(#40364134)
Which 90% of the time leave the drivers puzzled and wondering if you are about to do them any harm if they get too close. Been there, done that.
Re:A malicious vehicle can block "smart" intersections in th...
by Baeocystin on Tuesday May 14, 2024 @11:12PM
(#40362699)
You can attach a small permanent magnet somewhere on your bike's frame and it will trigger the ground loops. They're a common add-on for motorcycles, too.
Re:A malicious vehicle can block "smart" intersections in th...
by minitoar on Tuesday May 14, 2024 @11:59PM
(#40362963)
that doesn’t work for the majority of these sensors as they rely on inductance
Re:A malicious vehicle can block "smart" intersections in th...
by waste_monk on Wednesday May 15, 2024 @02:39AM
(#40363787)
In that case, simply install a chunk of steel under the bicycle - 150kg or so should be sufficient.
Re:A malicious vehicle can block "smart" intersections in th...
by minitoar on Wednesday May 15, 2024 @09:41AM
(#40366845)
I found steel rims to almost always work as long as you put it right over the middle line. In CA they often paint a little bike where you need to put it.
Re:A malicious vehicle can block "smart" intersections in th...
by loa_in_ on Thursday May 16, 2024 @10:39AM
(#40379030)
A simulated inductance circuit would do
Re:A malicious vehicle can block "smart" intersections in th...
by Baeocystin on Wednesday May 15, 2024 @09:24PM
(#40374296)
Is there a way to visually tell what kind of sensor loop you're dealing with?
I can verify that a magnet makes the difference for my steel-framed e-bike, but really there's only half a dozen lights in town (Gilroy, CA) that I frequently use.
I no longer bike through that intersection (because I don't need to very often, and because I found some nice side streets that happen to take me around it), but I doubt it's changed in the years since.