If you're playing with overclocking the RP2040 it's good to know that the flash chip might not be able to keep up with those higher clocks though, which leads to inscrutable crashes, and of course the official documentation doesn't endorse overclocking so they don't tell you how to work around that. The flash runs on a configurable clock divider defaulting to 4, so if you're running the CPU at double the nominal clock you can raise the divider to 8 to keep the flash running at its original speed.
I would add "no on-board flash" as a big negative, at least to me it makes it less of a "true" microcontroller.
The Pico has 2MB to 16MB on board flash with XIP in all the configurations AFAIK.
Fantastic documentation, even if in PDF form, which makes a bit less accessible for us and especially for LLMs training data crawlers. In general LLMs know a great deal more about ESP stuff than the RP2040.
came across to me, as if the entire item was a reason why you prefer the RP2040-based systems.
And I meant that the microcontroller itself (the RP2040 chip) lacks built-in flash. I realize it's on the boards instead, that is the thing I personally don't like since you can never have a single-chip solution.
This makes a huge difference for sensor systems etc. A pico/RP2040 cannot be powered by a battery for very long.
1. Vastly superior C SDK, and even the MicroPython support appears to have an edge.
2. Fantastic documentation, even if in PDF form, which makes a bit less accessible for us and especially for LLMs training data crawlers. In general LLMs know a great deal more about ESP stuff than the RP2040.
3. Almost every RP2040 can be overclocked to 400Mhz and work stable, and I could say basically every RP2040 can be stable at 350Mhz, so when comparing performances, account for this.
4. Very smart hardware capabilities: state machines for programmable pins (PIOs), great DMA support, hardware interpolators.
5. High quality hardware, and if you don't need the version with wireless, the cost is still quite reasonable. 3/4 euros/dollars per piece.
6. When you need the "W" one, the wireless chip the Pico uses has its own ARM processor, so you continue to have the two RP2040 cores spare for your application.
7. Memory mapped flash with execute in place. You can read from 0x1000000+offset just deferencing a pointer and that's it, you access your flash.
8. More GPIOs available.
The big disadvantage of the RP2040:
No SPI RAM support. At this point many ESP32 boards have built-in SPI and this makes memory a lot less a scarse resource.
To familiarize with the ESP family is useful since they are everywhere and are extremely cheap for what they offer. But still, I would start basically any new project where I have choice with the RP2040.