Re:After years of trying, the U.S. government may mandate sa...
by formerly_proven on Tuesday April 09, 2024 @10:35AM
(#39979902)
I doubt it's amazing for the bearings, but you can replace those fairly easily(*) on most motors.
(*) for people who have a workshop, anyway
Re:After years of trying, the U.S. government may mandate sa...
by rimunroe on Tuesday April 09, 2024 @01:33PM
(#39981895)
My dad was a machinist when he was younger. My siblings and I grew up with a well-equipped home shop, including a table saw, a drill press, a milling machine, and my dad's pride and joy: a two ton metal lathe. He drilled into us the importance of safety for all the tools, but the most vivid lesson was the story about the drill press: When he began his apprenticeship, he noticed a large photo on the wall of the shop of a long pale stringy thing. He asked what it was. It was a tendon which had been yanked out of the arm of someone whose hand got caught in a drill press. I still think about that whenever I use a drill press.
Re:After years of trying, the U.S. government may mandate sa...
by WalterBright on Tuesday April 09, 2024 @02:37PM
(#39982637)
In metal shop in high school, there was an 8*10 photo on the wall behind it of a long haired teen with about a third of the hair yanked out.
My dad (military) never did like long hair. He said it was just a convenient handle for someone to pull back your head and cut your throat.
And to be clear, it's well worth it IMO. Of all the tools I have in my shop, the Table Saw is easily the most dangerous. If I had long hair the Lathe would give it a good run for it's money though. I refuse to use a table saw without a sawstop (or similar safety break). The one I have and others I've used all have a key to insert to disable the safety device If need be.