Re:Low Cost Robot Arm
by mathiasgredal on Wednesday April 03, 2024 @04:00PM
(#39922322)
That was why OP suggested to have 2 motors on each joint, going in opposite direction. The problem with this is that you now have twice the amount of motors.
If your axis has high enough friction, then nothing will move when your actuator is in the decoupled backlash region, so you can compensate by adding the backlash amount to your target position whenever you switch directions. But that means you need more friction than tool force, with bigger motors and drivetrain to compensate. It's often easier just to build a system with zero backlash, then you can focus on tuning for system rigidity/resonance (as shown in your link).