Re:CNC Lasers for Cutting and Engraving
by sen on Friday January 26, 2024 @11:48PM
(#39152679)
The number of hobbyist diode laser machines that come with zero enclosure or air extraction is mind boggling. It then leads people to assume that stuff is optional. It’s not.
[ Parent
| on HN ]
Yes, it is very much negligent on the part of the manufacturers, on the other hand, at that price point you should look at these as things that you can make a laser cutter from, not a complete product. For instance, my machine was after the initial build quite far out of square, it was a parallelogram rather than a square and it took quite a bit of fiddling to get it to cut square pieces. It also didn't want to stay level and that too took some work to correct.
These weren't small errors, > 2 mm in either axis across the 61 cm x 61 cm work area of the machine. But now that it has been set up properly it is quite usable.
A 'real' machine has a calibration procedure that will allow you to correct for such errors as well as a large variety of others but these cheap machines just output stepper pulses in fire-and-forget mode without any feedback at all besides the ability to re-home in case they get lost (and the homing switches are so crummy that I'm amazed they work at all). But that usually implies a ruined work piece.