Not sure if you are talking about the PTFE molding process or not but this is just straight single shot injection molding, though it is possible to design multi shot processes with this setup. It’s just more complicated.
I used polypropylene which imo everyone should start with first because it’s by far the easiest to work with and pretty easily sourced off of eBay. It’s suitable for a wide variety of components for indoor use. For outdoor use you would want something like polycarbonate. I think working with polycarbonate would not be as lucrative in a home machine and here’s why: temp and pressures for polycarbonate are often a bit harder to achieve and the temps you need for molding polycarbonate are often at the upper limits of what these resins used to make the resin molds will tolerate. I think it’s possible though, but requires careful selection of a particular polycarbonate with the correct thermoplastic properties (such as lower melt temp) to operate within the acceptable ranges of your setup.
Were you using a PTFE release agent? Like this: https://www.antiseize.com/PTFE-SPRAY-HEAVY-COAT-Anti-Seize-L...
Polypropylene... Did this have (fiber)glass added?
The polypropylene I’ve used does not have fiberglass added. Though there are a LOT of options for thermoplastics, both ready made and custom mixed/compounded. You really learn to just go straight to the data sheet when thermoplastic shopping because that has all the relevant info you need