But realistically this is a matter of going back far enough, to lower the cost far enough? 10% are a good start but to stick to the topic, physical gyroscopes from decades ago are now replaced with MEMS ICs where the reduction in cost is magnitudes more then down to 10%. At a certain point the reduced cost makes it viable. The question is just has it been long enough?
While we wont get 90nm cheap enough, the question is what can we do on a hobby level (vs academia)? Because going from there (neglectable cost and technological requirements) to mass production will at some point be cheaper then the cost of setting up reproducible tooling for older high tech systems.
I am likely still off with 180nm, but there should be a level at which this makes economical sense. A level that gets cheaper to reach with technological progress / time.
My initial argument is that while you cant compete with ASML products in 2023, you will be able to economically compete with some of their older products once you go back far enough.
Even if it is 10% the cost of making the each of the individual components involved in making a relatively simple 90nm chip, you're still looking at vast costs.
If you're talking about making 30 chips in a university fab, sure, I'll concede that it is "possible" but if you're talking about propping up an industry built on products that require a herd of standardized "$0.30" parts made on legacy 90nm fabs, that ship has sailed.
Update your BOM and recertify or raise your costs by an order of magnitude.