And the past 12 V systems are dead easy to work on. On older cars that is, as soon as you have electronics and bus systems DIY basically requires deep car electronics knowledge and skills.
I haven’t done a ton of work on newer cars, but at least adding wiring for a hitch on my Kona EV was just as easy as any wiring I’ve done on my old truck.
Is a job like adding amps and better speakers trickier?
Hence, one needs some good knowledge around that, what to connect where.
In the old days, well, just go directly to the main battery with your aftermarket wiring and Bob's your uncle.
And none of that, battery management, which equipment can be connected where, has anything to do with the voltage but rather with all the other stuff modern cars have (bus management, battery management, ECus,...) all of which might or might not accept voltage and amp fluctuations very well.
My 1982 Range Rover has all of three fuses, so electrically I'm fine! Except the mess previous owners did to the original wiring... No idea why it is so difficult to just make your own wiring for after market accesories instead of butchering the OEM one up beyond recognition. It works, so I don't touch it. I have no idea why it works so...
> I have no idea why it works so...
I know that feeling haha. Adding wiring is so much easier than ripping up existing stuff ...
So how is this done on cars? Dores each manufacturer have their own proprietary bus system (what i imagine), or is there a standard that everyone can use?
Protocols like CAN, LIN, SENT and XCP are all standardised point to point and bus protocols for automotive stuff
I personally think the standardisation is actually a bit limiting[1]
Just like SpaceX found massive cost savings in using networking tech over hard wired interconnects, I think there’s a good chance China or other manufacturers might catch on
[1]I think interconnect failure rates are so low out of factory it’s not unethical to begin making things more lean, obviously with sufficient human safety testing
But I’m not an expert, just a former engineer working in an electronics shop…
I'm sure a 48V bus would solve all those F1 errors too.
Not an employee, but a very happy reoccurring customer.
Didn’t think there’d be more than one of us on here
Such a wild west company to work for. I enjoy meeting the many very bright people who work for us before they inevitably move onto other things
In an industrial setting it can be done but you need an extremely well designed and made termination point for one system and an interconnect for another, I’ve seen customers using floating grounds (and negative voltages) to enforce it
If upgrading to 24V or 48V I recommend having a solid grasp on circuit protection first, and if you have concerns, pay the 30 minutes or so labour for an automotive electrician to inspect it
I love that they don’t keep releasing new products so they can properly support their existing (extremely well made) lineup
Look into data centre infrastructure if you want to find interesting brands and solutions
A lot of automotive/DIY marketed gear seems to be reinventing the wheel and charging a much higher premium for it
I work at an electronics store in Australia
This week I had a customer dumbfounded why his 3,500W inverter almost caught fire
He was using 8-gauge wire (~56A max)
He needed 00-gauge (almost 300A max)
If he’d have run the system at 48V instead of 12V he’d have saved $200+ per metre on cabling his inverter
My advice on voltage selection for a vehicle is once you’re needing more than a few metres of 0-gauge, you should possibly increase the voltage of the system
High current cabling means expensive ANL, mega or other high performance fuses or other expensive circuit protection methods
I strongly believe that 48V systems are inherently safer than 12V systems when it comes to the public doing DIY work