USB inventor explains why the connector was not designed to be reversible

Re:USB inventor explains why the connector was not designed ... by parsimo2010 on Monday October 09, 2023 @04:24PM (#37825044)

Another trick is that the USB standard says the USB logo should be facing up, so you should always try it first with the logo facing up. Not every device follows that standard and not every device has a clear top/bottom, but this really cuts down on the proportion of failed attempts.

[ Parent | on HN ]

Re:USB inventor explains why the connector was not designed ... by globuous on Monday October 09, 2023 @04:32PM (#37825133)

No way! I didn't know that was part of the standard! Very useful "trick" indeed, unless of course, the USB port is placed vertically...

[ Parent | on HN ]

Re:USB inventor explains why the connector was not designed ... by cloudwalk9 on Monday October 09, 2023 @04:49PM (#37825322)

The pattern on the aluminum of the plug is also helpful in cases of predictable slot orientation (like a laptop, except a Dell Latitude from back in the day that had upright connectors on the back unless I'm misremembering). The side without the seam down the middle and instead a tiny rectangular cutout center but slightly lower than the other two cutouts, should face up. In the dark, the seam can be felt by lightly scraping with a fingernail.

[ Parent | on HN ]

Re:USB inventor explains why the connector was not designed ... by saratogacx on Tuesday October 10, 2023 @12:39AM (#37828549)

The holes face up, like the eyes of a sole or flatfish.

[ Parent | on HN ]