News for hackers. Stuff that matters.
Re:3D printing on OpenBSD? Yes, that’s a thing by microtherion on Friday September 15, 2023 @04:58PM (#37529047)
One difference is that sites like thingiverse allow the parametrization of OpenSCAD projects right on the site, so downloaders can customize their STL without needing to run OpenSCAD themselves. To the best of my knowledge, there is no such ability for FreeCAD.

For one of my projects, this seemed to be enough of a benefit that I redid my original FreeCAD design in OpenSCAD for eventual uploading.

There are no comments on this comment yet.