News for hackers. Stuff that matters.
Re:Successful room temperature ambient-pressure magnetic lev... by adrian_b on Friday August 04, 2023 @03:40AM (#36996726)
I believe that with the synthesis method proposed by the Korean team, i.e. by the chemical reaction between a certain kind of lead sulfate with copper phosphide, the chances of progress are slim.

The Korean team appears to have been stuck for several years by the lack of reproducibility of this synthesis method. While it was a great discovery that has shown that this material must have some very interesting properties, perhaps even superconductivity at ambient temperature and pressure, in order to be able to measure its properties and be able to evaluate the possible practical applications, a much more precise method for enforcing the desired crystal structure is required, than mixing powders and baking them into a ceramic.

Perhaps such a method for producing samples with deterministic properties would be to develop first a method to grow monocrystals of the special kind of lead phosphate that forms the base crystal structure, maybe by drawing the crystals from melt.

Once monocrystals of this kind of lead phosphate are available, they could be doped with copper, e.g. by ion implantation. By controlling and varying the parameters of the process, e.g. the angle of incidence and the velocity of the ions and the thermal profile used for annealing, it is likely that reproducible samples can be produced.

By this method it would be possible to produce only thin layers of LK-99, but that should be enough to enable the characterization of the material.

Moreover, because LK-99 is very fragile, it is unlikely that it could be used to make cables or coils. Practical uses where LK-99 would be deposited as thin films are much more likely.

As an alternative to ion implantation, which might be able to produce thicker layers, perhaps once monocrystals of the base lead phosphate are available it may be possible to develop some method of chemical vapor deposition, to grow epitaxially a layer of LK-99 over the base crystal.

Re:Successful room temperature ambient-pressure magnetic lev... by JRKrause on Friday August 04, 2023 @01:11PM (#37002826)
Drawing from melt to achieve a consistent crystal orientation was my first thought as well.

Looking at the Griffin paper, the Pb(2) site is described as being 1.08eV 'more energetically favorable'. I am having trouble understanding what this means.

Years back I did MOCVD semiconductor fabrication research, I never reached a mastery of it but I am still trying to leverage that understanding here.

During growth, adatoms that incorporate into proper crystal lattice locations enter a lower energy state compared to those in imperfect locations. The energy state is lower in the sense that it requires more energy to remove them from that location. Hence careful control of temperature allows you to selectively favor incorporation into these low energy locations e.g. choose a temperature high enough to remove adatoms from 'imperfect' locations but low enough to not remove them from 'perfect' (low energy) locations.

So when the author says 'energetically favorable' am I to understand this means the Pb(2) location represents a lower energy state (i.e. more difficult to remove Cu from this location) or the opposite? Or something else entirely?

Re:Successful room temperature ambient-pressure magnetic lev... by snovv_crash on Friday August 04, 2023 @03:02PM (#37004357)
Even thin films would enable highly efficient antenna-on-chip designs.