> of course in a properly built wheel usually all the spoke are under tension...
No, a properly built wheel all of the spokes are always under enough tension you can bounce a penny off them. Always.
Anyway, this sums it up pretty well. Someone has a longer memory than I:
https://news.ycombinator.com/item?id=36891231
If you’re talking about twisted spokes unwinding, you don’t have to reach zero load for that to happen. You just need to reduce the load enough so the rotational force overcomes friction. Tension will also try to unwind a screw as well. But the thread pitch on spokes is very fine, which lessens that force. If you build spokes like wood screws we would have problems and that has nothing to do with reaching 0 newtons.
You can release a lot of those tensions by squeezing the spokes mid build. Just don’t wait until they’re too tight to do it. I had a pulse in my rear wheel that probably came from doing that wrong the first time. Unless it was a factory defect, I must have overtensioned and warped a brand new Mavic aero rim ever so slightly. Expensive lesson, but it could have been worse.
of course in a properly built wheel usually all the spoke are under tension...
i was just demonstrating the fact that the spokes on the upper half of the wheel are supporting the hub and are under greater tension than the bottom ones, the spokes on the bottom half of the wheel should remain in tension, but only through the fact that they are already under tension applied during the building of the wheel.
the fact that the wheel works by tension of the spokes becomes obviously apparent when you start to remove the pretension and then the spokes will feel loose on the bottom half. of course you'd never want to ride a wheel like that because it will quickly become out of true.. just like a walmart wheel.