After breaking my second laptop with fluids (first was ruined with coffee; second with it standing in water, which was rain accumulated in my not properly closed "watertight" bag) I started buying Thinkpads. They have specially designed "Fluid drains". Because all laptop manufacturors know that spills are one of the highest death-causes for laptops. http://youtu.be/d7cvi00OZDM
But as always, you shouldn't place your drinks directly to all kind of electronic stuff. It's common sense.
However, there is no excuse not to design something with safety in mind.
If you look at the base, the edge rim of it is where it seeped in and sat in the curved section like a pool when oriented normally. There was at least 10ml of water which had been sucked off the table via that rim. The logical step is "isolate power". Any movement of the device resulted in the water spilling onto the logic board.
Pictures: http://www.ifixit.com/Guide/Installing-MacBook-Pro-13-Inch-U...
Now TBH I've personally done this with an acer timeline. I yanked the battery out in 5 seconds flat and hung it up to dry. It was fine the next day.
One glass of water on the desk (not in the machine!). Capillary action sucked water around the seal on the base. It was turned over to remove the battery and the sucked up water rained on the logic board resulting in all sorts of crackling, smoke etc and one dead MacBook.
Being a qualified and experienced EE, I'm qualified to say that it's electronics 101 to be able to isolate power (like every other vendor allows).