News for hackers. Stuff that matters.
Re:My foxhole radio by jgrahamc on Tuesday February 07, 2012 @07:54AM (#3561533)
Thanks for the additional advice. I was planning to make a capacitor out of foil and newspaper interleaved. One day when I've finished all the other things I want to play around with...
Re:My foxhole radio by linker3000 on Tuesday February 07, 2012 @08:13AM (#3561588)
The other method is using a variometer (inductive), which is easier than making a variable capacitor:

http://www.crystalradio.net/crystalsets/hassell/index.shtml

Newpaper will be 'fun' to work with as its moisture content will vary with environmental conditions, making its dielectric constant not very..erm..constant - unless you impregnate it with wax or a lacquer.

(Made plenty of crystal sets during my teen years in the mid 70s-80s)

Re:My foxhole radio by Craiggybear on Tuesday February 07, 2012 @08:34AM (#3561659)
Good link to variometer page -- thanks.
Re:My foxhole radio by ja27 on Tuesday February 07, 2012 @08:23AM (#3561617)
There are lots of ways to homebrew variable capacitors. A sheet of glass and two pieces of scrap copper does well.

I have a "crystal" radio (uses a modern diode) all built on a paper towel tube. The coil is wound on the tube like usual but at the other end of the tube there's also a layer of foil and a smaller tube with a layer of foil that slides inside that to make a variable capacitor.

Re:My foxhole radio by ul5255 on Tuesday February 07, 2012 @04:09PM (#3563640)
I once found this site with lots of interesting projects: http://www.sparkbangbuzz.com/
Re:My foxhole radio by Craiggybear on Tuesday February 07, 2012 @08:39AM (#3561676)
Good VC advice.

Also, I find that inserting a ferrite rod into the coil (or winding the coil around the ferrite rod to begin with) makes tuning much more effective (sharper) and makes the audio signal much stronger. A steel or iron 6" nail also works if you want to dispense with the ferrite rod.

Re:My foxhole radio by Craiggybear on Tuesday February 07, 2012 @08:29AM (#3561641)
I live very close to the BBC regional broadcast transmitters (100KW apiece) and since boyhood I've made loads of crystal sets as well. A few feet of wire often being quite sufficient as an antenna and the radiator pipe as an earth connection. A good earth connection is very important to the effectiveness of a crystal set.

I made a single transistor regenerative set next and because the local BBC signal was so powerful I literally didn't even need an antenna at all!

Another single transistor was all that was required to drive a speaker loud and clear.