If in mass production, I see nothing that would prevent it from being cheaper than a comparable LED lamp.
I am not familiar with the technology used to make the incandescent band made of carbon nanotubes and boron nitride ceramic, but everything else is made with standard equipment that is widely available.
It must be hermetic, to keep the argon inside and the air outside, for the lifetime of the bulb.
It contributes to the high efficiency, by reflecting both the visible and the infrared light and preventing thus the heat loss from the lamp.
Nonetheless, alumina is less fragile than ordinary glass.
It might be possible to replace the quartz window with some kind of glass window, for a lower cost, but not with any kind of plastic, because it must also be hermetic and it must be usable as a substrate for thin film deposition in vacuum and it should have a coefficient of thermal expansion matched to those of the multiple layers of the infrared-reflecting filter.
I didn't mention this in my other comment because I thought the use of alumina could be avoided, but I suggest you look up the price of some optical sapphire (ie transparent alumina) before you get excited about that. Even for a tiny, flat circle you're looking at around ten bucks. A bulb would likely be harder.
https://www.uqgoptics.com/catalogue/optical-windows/sapphire...
The light exits the lamp through a flat window, which is made of quartz in the prototype, but in mass production it is likely that some kind of alumosilicate glass or borosilicate glass would be fine for it.
>Fabrication of the VTIRF window
>The quartz substrate with a size of 25 mm by 50 mm is cleaned by bath ultrasonication using acetone, ethanol, and deionizing water for 10 min. The Al2O3 and HfO2 layers are deposited by atomic layer deposition (R200, PICOSUN) at 255°C using trimethylaluminum (Strem Chemicals) and tetrakis(dimethylamido)hafnium(IV) (Strem Chemicals) as precursors, respectively. The oxidizing agent is H2O. The precursor carrier gas is N2 (99.999% purity, Shanghai Weichuang Gas). The Ag-Ge alloy and SiO2 layers are deposited by electron beam evaporation (PVD 75, Kurt J. Lesker) in vacuum.
I'm no expert on how LEDs are made, but this coating certainly doesn't assemble itself.
The article mentions explicitly all the equipment that has been used in the fabrication of the prototype.
The fabrication of any semiconductor device, such as LEDs, includes many more such vapor deposition steps done in vacuum, using the same machines, but with much more stringent requirements for cleanliness and defect control.
Any defects in the deposition steps for such a lamp window will just reduce the efficiency of some lamps by a small fraction of a percent, while during LED fabrication they would have made unusable LEDs that would have been dumped.