Re:Wilson's 3D-printed basketball is full of holes but never...
by thelock85 on Tuesday February 21, 2023 @09:00PM
(#34890572)
I think this is a valid concern for pro, semi-pro, collegiate and competitive recreational players. Not so sure for the millions of other players who play with crappy, uneven, knotted, too rough/smooth “ordinary” balls everyday. Of course that doesn’t mean there is a market for it.
Re:Wilson's 3D-printed basketball is full of holes but never...
by sublinear on Tuesday February 21, 2023 @09:47PM
(#34890967)
I don't believe ordinary balls would experience the same level of degradation simply because the pressurized air inside is most of what makes it bounce
Re:Wilson's 3D-printed basketball is full of holes but never...
by doubled112 on Tuesday February 21, 2023 @10:25PM
(#34891242)
I've had basketballs fail. Suddenly your ball has a lump. Happens after a hard hit sometimes.
On the 3D printed one, I'd assume the opposite problem. A hard hit causes a dead spot or actual indent.
Both make it hard to play with.
i.e. It doesn't need air, but does it bounce the same after thousands of bounces and hours of sunlight? Is the wear evenly distributed when left in the sun but not used? What about when it is used, but damage occurs for other reasons?