News for hackers. Stuff that matters.
Re:CAD Sketcher, free and open-source project bringing CAD l... by TheSpiceIsLife on Sunday February 19, 2023 @08:34AM (#34857425)
The chamfer applies to the first hole only, unless it is a copy of the first.

Any changes to the first hole only apply to the first hole, unless that second hole is a linked copy of the first.

____

Is there an argument against this general solution?

Re:CAD Sketcher, free and open-source project bringing CAD l... by jstanley on Sunday February 19, 2023 @09:42AM (#34857934)
Who's to say which hole is the "first"?
Re:CAD Sketcher, free and open-source project bringing CAD l... by mgdlbp on Sunday February 19, 2023 @10:28AM (#34858368)
From the user's perspective, the circle that was originally drawn, which wasn't touched when adding a second circle to the sketch. If the original was deleted, then it's unclear (possibly assume the first replacement).

IIRC (not testing now) FreeCAD already handles this example correctly. You can add circles to the sketch and the chamfer stays put. If you delete the circle and add a new one, it appears on the new hole. But if you add a square instead, it moves to a random edge of the rectangular hole.

The edge of the rectangular hole is actually a loop of four edges, so this is understandable. Commercial software can fix some of these cases - I don't think the Freecad link branch can, but it does at least detect that the original geometry was deleted and raises an error asking you to reselect instead of allowing the chamfer to move. Not dissimilar UX to when you mess with something that Fusion can't handle, I say.

Re:CAD Sketcher, free and open-source project bringing CAD l... by phkahler on Sunday February 19, 2023 @05:31PM (#34862545)
If the first is deleted then everything done to it afterward should be gone.